Unveiled: the secret to taking apart your makita drill in minutes

Whether you’re a seasoned DIY enthusiast or a professional contractor, understanding how to take apart a Makita drill is an essential skill. Whether you need to perform repairs, replace worn-out parts, or simply deep clean your tool, this comprehensive guide will provide you with the step-by-step instructions you need.

Safety Precautions

Before beginning any disassembly work, ensure you unplug the drill and wear appropriate safety gear, including gloves and safety glasses.

Tools and Materials Required

• Screwdriver (Phillips and flathead)
• Allen wrench (if necessary)
• Hammer (optional)
• Soft-bristled brush
• Cleaning solution
• Lubricant (optional)

Step-by-Step Disassembly

1. Remove the Battery

Locate the battery release button on the drill’s handle and press it to detach the battery.

2. Unscrew the Handle Screws

Using a Phillips screwdriver, remove the two screws securing the handle to the body of the drill.

3. Separate the Handle

Gently pull the handle away from the body of the drill.

4. Remove the Motor Cover Screws

Locate the screws holding the motor cover in place. These screws may be covered by rubber caps, which you can remove with a flathead screwdriver.

5. Remove the Motor Cover

Carefully lift off the motor cover to expose the motor and other internal components.

6. Disconnect the Wires

Identify the wires connecting the motor to the drill’s controls. Gently disconnect these wires using a small flathead screwdriver or needle-nose pliers.

7. Remove the Motor

Use an Allen wrench or a flathead screwdriver to loosen the bolts holding the motor in place. Once loose, carefully lift out the motor.

8. Clean and Inspect

Use a soft-bristled brush to remove any dust or debris from the internal components. Inspect each part for wear or damage.

9. Reassemble the Drill

Follow the disassembly steps in reverse order to reassemble the drill. Ensure all screws are tightened securely and that the wires are properly reconnected.

Post-Disassembly Care

Cleaning

Use a cleaning solution to wipe down the internal components and remove any remaining dust or debris.

Lubrication

If desired, apply a small amount of lubricant to moving parts, such as the chuck and gears, to ensure smooth operation.

Troubleshooting

Refer to the FAQ section below for answers to common issues you may encounter during disassembly.

Quick Answers to Your FAQs

1. How do I remove the chuck?

The chuck may require a special key or a hammer to remove. Refer to your drill’s specific user manual for instructions.

2. Why is the motor making a rattling noise after reassembly?

Ensure that the motor is securely fastened and that no wires are pinched or loose.

3. What should I do if a screw is stripped?

Use a screw extractor or a hammer to loosen the stripped screw.

4. How often should I disassemble my drill for cleaning?

Regular disassembly for cleaning depends on usage frequency. As a general guideline, disassemble and clean your drill every 6-12 months.

5. Can I use a regular screwdriver to remove the motor cover screws?

While possible, using a Phillips screwdriver is recommended to prevent damaging the screws.

6. Where can I find replacement parts for my Makita drill?

You can purchase replacement parts from authorized Makita dealers or online retailers.

7. Is it necessary to lubricate the drill after disassembly?

Lubrication is optional but recommended to extend the life of moving parts and prevent wear.

8. What is the purpose of the rubber caps on the motor cover screws?

The rubber caps protect the screws from dust and debris and prevent accidental loosening.

9. How do I know if the motor is damaged?

Signs of motor damage include excessive sparking, unusual noises, or a burning smell.

10. Can I disassemble my drill if it is still under warranty?

Disassembling your drill may void the warranty. Refer to your drill’s user manual for specific guidelines.