Diy maytag washer tub bearing replacement: a step-by-step guide to restore your appliance
What To Know
- Replacing a Maytag washer tub bearing might seem like a daunting task, but it’s entirely doable with the right tools and a bit of know-how.
- Locate the tub clamp at the bottom of the tub and remove the bolts using a socket wrench.
- Place the new bearing into the tub assembly and tap it into place using a hammer and a socket.
Replacing a Maytag washer tub bearing might seem like a daunting task, but it’s entirely doable with the right tools and a bit of know-how. This comprehensive guide will walk you through every step of the process, empowering you to restore your washer to its former glory.
Tools and Materials You’ll Need
- New Maytag washer tub bearing kit
- Socket wrench
- Adjustable wrench
- Screwdriver
- Pliers
- Hammer
- Pry bar
- Bucket
- Towels
Step-by-Step Instructions
1. Unplug the Washer and Turn Off Water Supply
Safety first! Disconnect the washer from the power source and shut off the water supply at the valves.
2. Remove the Top Panel and Agitator
Remove the screws securing the top panel and lift it off. Next, detach the agitator by removing the cap and unscrewing the bolt.
3. Unbolt the Tub Clamp
Locate the tub clamp at the bottom of the tub and remove the bolts using a socket wrench.
4. Disconnect the Hoses and Wires
Disconnect the hoses and wires connected to the tub, including the water inlet hose, drain hose, and power cord.
5. Tilt the Washer and Remove the Tub
Carefully tilt the washer onto its side. Use a pry bar to gently pry the tub away from the base and lift it out.
6. Remove the Old Bearing
Use a hammer and screwdriver to tap out the old bearing from the tub assembly.
7. Install the New Bearing
Place the new bearing into the tub assembly and tap it into place using a hammer and a socket.
8. Reassemble the Washer
Reverse the disassembly steps to reassemble the washer. Connect the hoses and wires, bolt on the tub clamp, and replace the agitator and top panel.
9. Test the Washer
Plug the washer back in and turn on the water supply. Run a test cycle to ensure the bearing replacement was successful.
Troubleshooting Tips
- If the washer is still noisy after replacing the bearing, check for other damaged components such as the motor or drive belt.
- If the tub is difficult to remove, use a pry bar to gently pry it away from the base.
- If you encounter any leaks after reassembling the washer, check the hose connections and tighten them if necessary.
Summary: A Job Well Done
Replacing a Maytag washer tub bearing is a satisfying accomplishment. By following these step-by-step instructions, you’ve restored your washer to optimal functionality and saved yourself a costly repair bill. Enjoy the peace of mind that comes with a well-maintained washer!
Frequently Asked Questions
Q: How often should I replace the tub bearing in my Maytag washer?
A: The lifespan of a tub bearing varies depending on usage. Generally, it’s recommended to replace it every 5-7 years.
Q: Can I use any type of bearing for my Maytag washer?
A: No, it’s crucial to use a bearing specifically designed for your Maytag washer model. Using the wrong bearing can lead to damage or malfunction.
Q: What are the signs of a damaged tub bearing?
A: Common signs include excessive noise, leaking water, and difficulty agitating the clothes.