Replace your broken kitchenaid dishwasher food chopper: a step-by-step guide

If your KitchenAid dishwasher‘s food chopper has seen better days, fret not! Replacing it is a relatively simple task that can be completed in under an hour with the right tools and a bit of know-how. Follow our comprehensive guide to get the job done right and restore your dishwasher to its former glory.

Tools and Materials You’ll Need:

• New KitchenAid dishwasher food chopper assembly (matching your dishwasher model)
• Phillips screwdriver
• Flathead screwdriver
• Needle-nose pliers (optional)
• Soft cloth

Safety Precautions:

• Unplug your dishwasher from the power outlet.
• Turn off the water supply to your dishwasher.
• Wear safety gloves to protect your hands.

Step-by-Step Instructions:

1. Remove the Dishwasher Door:

• Open the dishwasher door completely.
• Locate the screws on the inside edge of the door, near the top.
• Use a Phillips screwdriver to remove the screws and carefully lift the door off its hinges.

2. Access the Food Chopper Assembly:

• Once the door is removed, you will see the food chopper assembly located in the bottom center of the dishwasher tub.
• It is typically secured by a few screws or clips.

3. Disconnect the Food Chopper Assembly:

• Use a Phillips screwdriver or flathead screwdriver to remove the screws or release the clips that hold the food chopper assembly in place.
• Carefully lift the assembly out of the dishwasher tub.
• Disconnect the electrical connector by pressing on the release tab and pulling it straight out.

4. Remove the Old Food Chopper:

• The old food chopper may be held in place by a few screws or clips.
• Use a Phillips screwdriver or flathead screwdriver to remove these fasteners.
• Carefully separate the old food chopper from the assembly.

5. Install the New Food Chopper:

• Align the new food chopper with the assembly.
• Secure it in place with the screws or clips that you removed earlier.
• Ensure that the electrical connector is properly plugged in.

6. Reinstall the Food Chopper Assembly:

• Carefully place the food chopper assembly back into the dishwasher tub.
• Align it properly and secure it with the screws or clips that you removed earlier.

7. Reattach the Dishwasher Door:

• Carefully lift the dishwasher door back onto its hinges.
• Align the door and secure it with the screws that you removed earlier.
• Check that the door opens and closes smoothly.

Finishing Up:

• Turn the water supply back on to your dishwasher.
• Plug the dishwasher back into the power outlet.
• Run a short cycle to test the new food chopper assembly.

Troubleshooting Tips:

• If the dishwasher does not drain properly after replacing the food chopper, check for any clogs in the drain hose or garbage disposal.
• If the food chopper makes a loud noise when running, check if it is properly installed or if there is any debris stuck in the blades.
• If the food chopper does not chop food effectively, check if the blades are sharp or if the assembly is properly connected.

Wrapping Up: The Recipe for a Perfectly Chopped Future

Replacing your KitchenAid dishwasher food chopper is a straightforward task that can save you time and money in the long run. By following the steps outlined in this guide, you can restore your dishwasher to its optimal performance and enjoy perfectly chopped food for years to come.