Troubleshoot and replace your kenmore dishwasher pump like a pro video
What To Know
- Replacing the pump is a relatively straightforward task that you can handle yourself with the right tools and a little know-how.
- Replacing a Kenmore dishwasher pump is a relatively simple task that can be completed in under an hour.
- By following these step-by-step instructions, you can save yourself the cost of hiring a professional and ensure that your dishwasher is back up and running in no time.
If your Kenmore dishwasher is acting up and not draining properly, the culprit might be a faulty pump. Replacing the pump is a relatively straightforward task that you can handle yourself with the right tools and a little know-how. This comprehensive guide will walk you through the entire process of how to replace a Kenmore dishwasher pump, step by step.
Tools and Materials You’ll Need:
- New Kenmore dishwasher pump
- Screwdriver (Phillips head)
- Pliers
- Bucket or pan
- Towels or rags
Safety Precautions:
Before you begin, disconnect the dishwasher from the power source and water supply. Turn off the water valve under the sink and unplug the dishwasher from the outlet.
Step-by-Step Instructions:
1. Remove the Lower Access Panel:
Locate the lower access panel at the bottom of the dishwasher door. Remove the screws that hold it in place and gently pull the panel off.
2. Unplug the Dishwasher:
Once the panel is removed, you will see the dishwasher’s electrical connections. Unplug the dishwasher from the power outlet.
3. Disconnect the Water Supply:
Locate the water supply line connected to the dishwasher. Use pliers to loosen the nuts and disconnect the line. Allow any remaining water to drain into a bucket or pan.
4. Locate the Pump:
The pump is usually located at the bottom of the dishwasher, near the back. It is typically a black or gray cylinder-shaped component.
5. Disconnect the Pump:
Use a screwdriver to remove the screws that hold the pump in place. Carefully disconnect the pump from the motor and other hoses.
6. Install the New Pump:
Take the new pump and align it with the mounting bracket. Secure it using the screws you removed earlier. Connect the pump to the motor and hoses.
7. Reconnect the Water Supply:
Reconnect the water supply line to the dishwasher. Tighten the nuts securely.
8. Plug in the Dishwasher:
Plug the dishwasher back into the power outlet.
9. Reinstall the Lower Access Panel:
Put the lower access panel back in place and secure it with the screws.
10. Test the Dishwasher:
Turn on the water supply and power to the dishwasher. Run a short cycle to ensure that the new pump is working correctly.
Troubleshooting:
If you encounter any issues during the replacement process, here are some troubleshooting tips:
- Leaking: Check that all connections are tight and that the water supply line is properly secured.
- Pump not running: Verify that the dishwasher is plugged in and that the power is turned on.
- Dishwasher not draining: Make sure the drain hose is not kinked or clogged.
The Bottom Line:
Replacing a Kenmore dishwasher pump is a relatively simple task that can be completed in under an hour. By following these step-by-step instructions, you can save yourself the cost of hiring a professional and ensure that your dishwasher is back up and running in no time.
Frequently Asked Questions:
Q: How often should I replace my Kenmore dishwasher pump?
A: The lifespan of a dishwasher pump varies depending on usage, but generally, it should last for several years.
Q: Can I use a different brand of pump in my Kenmore dishwasher?
A: It is recommended to use a Kenmore-branded pump to ensure compatibility and proper performance.
Q: Is it safe to replace the pump myself?
A: Yes, as long as you follow the safety precautions and instructions carefully.