Bye-bye broken dishwasher! the ultimate guide to replacing the control board and restoring order
What To Know
- The control board is usually located at the top or bottom of the dishwasher, behind the front panel.
- Replacing a GE dishwasher control board can be a straightforward task with the right tools and instructions.
- The cost of a new GE dishwasher control board can range from $100 to $250, depending on the model and where you purchase it.
If your GE dishwasher is acting up, one of the potential culprits could be a faulty control board. Replacing this essential component can restore your dishwasher to its former glory. This detailed guide will walk you through the step-by-step process of how to replace a GE dishwasher control board, empowering you to tackle this repair project with confidence.
Tools and Materials
Before you begin, gather the necessary tools and materials:
- Screwdriver
- Nut driver
- Needle-nose pliers
- Wire strippers
- Electrical tape
- New GE dishwasher control board
Safety Precautions
- Unplug the dishwasher from the power outlet.
- Turn off the water supply to the dishwasher.
- Wear gloves to protect your hands.
Step-by-Step Instructions
1. Remove the Dishwasher Door
- Open the dishwasher door and locate the screws holding the door in place.
- Remove the screws and carefully lift the door off its hinges.
2. Remove the Front Panel
- Locate the screws securing the front panel to the dishwasher.
- Remove the screws and carefully pull the front panel forward and off.
3. Locate the Control Board
- The control board is usually located at the top or bottom of the dishwasher, behind the front panel.
- It is a rectangular box with wires and connectors attached to it.
4. Disconnect the Wires
- Using a nut driver, carefully loosen the nuts holding the wires to the control board.
- Pull the wires off the terminals.
- Note the position of each wire so you can reconnect them correctly later.
5. Remove the Control Board
- Remove the screws holding the control board in place.
- Carefully lift the control board out of the dishwasher.
6. Install the New Control Board
- Align the new control board with the mounting holes.
- Secure it with the screws.
- Reconnect the wires to the terminals, tightening the nuts securely.
7. Reassemble the Dishwasher
- Reinstall the front panel and secure it with the screws.
- Lift the dishwasher door back onto its hinges and secure it with the screws.
8. Test the Dishwasher
- Plug the dishwasher back into the power outlet.
- Turn on the water supply.
- Run a test cycle to ensure the dishwasher is functioning properly.
Troubleshooting Tips
- If the dishwasher still does not work after replacing the control board, check the wiring connections and ensure they are secure.
- If the dishwasher shuts off prematurely, check the door latch and make sure it is closing properly.
End Note
Replacing a GE dishwasher control board can be a straightforward task with the right tools and instructions. By following the steps outlined in this guide, you can restore your dishwasher to optimal performance and avoid costly repairs. Remember to always unplug the dishwasher and turn off the water supply before performing any maintenance or repairs.
Basics You Wanted To Know
Q: How do I know if my GE dishwasher control board needs to be replaced?
A: Symptoms of a faulty control board can include the dishwasher not starting, not draining, or not heating the water properly.
Q: Can I repair the dishwasher control board myself?
A: While it is possible to repair a control board, it is generally not recommended unless you have experience with electrical repairs.
Q: How much does it cost to replace a GE dishwasher control board?
A: The cost of a new GE dishwasher control board can range from $100 to $250, depending on the model and where you purchase it.