Simple steps for emergency mid-cycle dishwasher drainage (frigidaire)
What To Know
- The drain pump is typically located at the bottom of the dishwasher, behind the front kickplate.
- Reconnect the drain hose to the drain pump by pushing it on firmly until it clicks into place.
- Draining a Frigidaire dishwasher mid-cycle is a straightforward process that can be completed in a few simple steps.
Are you facing a mid-cycle malfunction in your Frigidaire dishwasher, leaving you with a sink full of soapy water? Don’t worry; draining a Frigidaire dishwasher mid-cycle is a relatively simple task that you can tackle yourself. This comprehensive guide will provide you with step-by-step instructions and troubleshooting tips to help you get your dishwasher back up and running in no time.
Safety Precautions
- Unplug the dishwasher from the electrical outlet.
- Turn off the water supply to the dishwasher.
- Wear gloves to protect your hands from sharp edges.
Step 1: Locate the Drain Pump
The drain pump is typically located at the bottom of the dishwasher, behind the front kickplate. Remove the kickplate by unscrewing the screws that hold it in place.
Step 2: Remove the Drain Hose
Locate the drain hose, which is connected to the drain pump. Carefully disconnect the hose from the pump by squeezing the clamp and pulling it off.
Step 3: Drain the Water
Place a bucket or shallow pan under the dishwasher. Tilt the dishwasher slightly forward and allow the water to drain into the container. Be patient, as this process can take several minutes.
Step 4: Inspect the Drain Hose
Once the water has drained, inspect the drain hose for clogs or kinks. Remove any obstructions you find.
Step 5: Reattach the Drain Hose
Reconnect the drain hose to the drain pump by pushing it on firmly until it clicks into place. Tighten the clamp to secure the connection.
Step 6: Replace the Kickplate
Reinstall the kickplate by screwing it back into place.
Step 7: Reset the Dishwasher
Plug the dishwasher back in and turn on the water supply. Press the “Start/Reset” button to resume the wash cycle.
Troubleshooting
- Dishwasher won’t drain after resetting: Check the drain hose again for clogs or kinks. The drain pump may also be faulty and need to be replaced.
- Water leaks from the dishwasher: Inspect the drain hose and connections for leaks. Tighten any loose connections or replace the hose if necessary.
- Dishwasher makes a loud noise when draining: The drain pump may be clogged or damaged. Clean the pump or replace it if needed.
Takeaways
Draining a Frigidaire dishwasher mid-cycle is a straightforward process that can be completed in a few simple steps. By following the instructions carefully, you can quickly resolve the issue and restore your dishwasher to its proper functioning.
What You Need to Learn
Q: Why is my Frigidaire dishwasher not draining mid-cycle?
A: The most common cause is a clogged drain hose or drain pump. Inspect the hose and pump for obstructions and remove them.
Q: Can I use a wet/dry vacuum to drain the dishwasher?
A: Yes, you can use a wet/dry vacuum to remove the water from the dishwasher. However, be sure to use the appropriate attachment to avoid damaging the vacuum.
Q: How often should I clean the drain hose and pump?
A: It is recommended to clean the drain hose and pump every 6-12 months to prevent clogs and ensure proper drainage.